HT-HD01 FAQ

The configuration page cannot be accessed when reset up via Wi-Fi.

Do not enter the reset up mode via Wi-Fi while connecting the network cable. If this situation occurs, please unplug the power and network cable, and then re-enter the configuration mode.

How do you get device’s information and IP address?

Refer to Get dongle IP address

Look in the upstream router: Introduction ht-h7608 latest documentation
Connect to the 2.4GWi-Fi provided by the dongle and enter “192.168.1.1” or “10.42.0.1” in the browser (depending on the mode of operation of the device, if you are not sure which one to enter, you can try both). You will see the IP of the connected device and the IP of the Dongle itself.

Resetting devices

Factory resetting

If you forget your account password and can’t connect to your device, please long press the device button for 7 seconds to completely reset. After reset, please follow the above steps.

To maximize the transmission distance

To maximize the transmission distance of your device, consider the following strategies:

Reduce Bandwidth. Generally, the smaller the bandwidth of the AP, the longer the transmission distance. Lower bandwidth increases sensitivity and range but reduces the data rate.
The communication quality between the AP and STA is best when their antennas are parallel. Typically, positioning both antennas vertically upward ensures optimal performance.
Place the antennas within line of sight (LOS) to minimize obstructions.
Install the AP antenna in a high, unobstructed location (e.g., on a rooftop or pole) to maximize coverage and reduce interference.